Advanced Energy Thyro-S Manual page 26

26
DESCRIPTIOn:
Thyro-S, Thyro-A and Thyro-AX
Pulse blocking active
(bridge X2.1-X2.2open)
Mains frequency is 60 hz
U limiting active
I limiting active
P limiting active
Relay status (0=relay off/ 1=relay
on)
Busmodul aktiv (0=no bus
module/1=bus modul active)
Thyristor short-circuit (Thyro-S)
failure in rotating field/
phase (only Thyro-A 2A or 3A/
Thyro-AX 2A or 3A)
TAB. 9 B ERROR fLAGS (STATUS)
Thyro-A/Thyro-AX
LEDs
Bit0 Pulse Inhibit LED on
Bit2 none
Bit4 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
Bit5 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
Bit6 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
Bit8 none
Bit11 none
Bit14 only with Thyro-S
Bit15 Pulse Inhibit LED and Test
LED flash slowly simulta-
neously
* The table only shows the default configuration of the relay function.
It can be configured by Thyro-Tool family, which message shall be shown by
the relay an which not.
The relay only exists in h RL1, h RLP1, h RL2 or h RLP2 device, not in the h1
types.
Thyro-S
RELAy* LEDs
energised none
energised none
energised only with Thyro-A/Thyro-AX
energised only with Thyro-A/Thyro-AX
energised only with Thyro-A/Thyro-AX
on/off none
energised none
--- Test-LED a. Load fault LED
flash slowly
alternately
dropped out only with Thyro-A/Thyro-AX
RELAy*
energised
energised
---
---
---
on/off
energised
dropped out
---