Maintenance - TMC Aquarium REEF-Skim PRO 500 Instructions For Installation And Use Manual

USE WITH OZONE
REEF-Skim PRO Protein Skimmers and the supplied pump are suitable for use with ozone.
To use with ozone, simply connect the outlet of the ozone generator to the ozone injection
nipple (this will be covered with a small cap) on the bottom of the air silencer. Turn the air
adjustment dial so as much air as possible is sucked through the ozone unit, but without
affecting bubble production performance. We highly recommend using a V
Generator for safe ozone dosing.
USEFUL TIP: Although ozone gas enhances the skimming process, should a reduction in
skimming performance be noticed following the addition of an ozone generator there is a good
chance that the ozone generator is either blocked or is limiting the amount of air being drawn
into the venturi injection system. This problem is easily overcome by increasing the amount of
air that is allowed through by turning the air adjustment dial as appropriate.
Caution: Ozone is dangerous and should be used with care. Always refer to the instructions
and safety guidelines of the ozone generator manufacturer.

MAINTENANCE

Caution: To avoid possible electric shock, special care should be taken when using
this electrical appliance near water.
Caution: Always isolate the pump from mains electricity before installing or
carrying out any maintenance to the skimmer.
REEF-Skim PRO Protein Skimmers should need very little adjustment and maintenance once
set up correctly. However due to salt deposits and the high calcium level in marine aquariums
it is common for deposits to build up and therefore it is recommended that the skimmer and
venturi are cleaned periodically with a bottle brush or similar. The air line may also need to be
replaced periodically.
1. To operate efficiently, the skimmer must be in use 24 hours a day.
2. Make sure all connections are tightly secured.
3. Check regularly that the skimmer is functioning properly and producing the desired foam
consistency and waste material. Adjust water level adjustment dial as required.
4. When the collection cup is full or dirty, ensure all waste material is removed. The more
frequently the cup is cleaned, the more efficient the skimmer will be.
5. Remove the collection cup by gently pulling the cup upwards, keeping it level. Clean any
organic build up, salt and/or calcium deposits from the collection cup and neck.
6. Ensure the outlet and inlet pipe assemblies and the air inlet on the venturi are clean and
free of blockages.
7. Clean the pump regularly to ensure it does not become clogged with debris or detritus
(refer to separate pump instructions for full maintenance details).
8. During cleaning and/or maintenance ensure that the collection cup O ring is clean and free
from cracks and detritus, salt and/or calcium deposits. Make sure the O ring is correctly
re-positioned after cleaning. Failure to do so could result in leaks when the water pump is
switched on. Lubricate all O rings with silicon grease periodically.
7
Ozone Ozone
2