Mercedes-Benz GLE Series 2020 Operator's Manual page 61

O When using a Group I forward-facing
child restraint system: remove the head
restraint from the respective seat, if possi‐
ble. In addition, the backrest of the child
restraint system must, as far as possible, lie
flat against the backrest of the vehicle seat.
Once the child restraint system has been
removed, replace the head restraints imme‐
diately and adjust them correctly.
O For certain child restraint systems in weight
group II or III, there may be restrictions on
the maximum size setting, e.g. due to possi‐
ble contact with the roof.
O The child restraint system must not be ten‐
sioned between the roof and the seat cush‐
ion and/or be installed facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraints. Adjust
the head restraints accordingly.
Before every journey, make sure that the
#
LATCH-type (ISOFIX) child restraint system is
engaged in both mounting brackets in the
vehicle.
* NOTE Be careful not to damage the seat
belt for the center seat when installing
the child restraint system
Make sure that the seat belt is not trap‐
#
ped.
Occupant safety
Vehicles with rigid rear seats:
1 LATCH-type (ISOFIX) mounting bracket
Remove and stow away covers 1
#
mounting brackets in the vehicle.
Attach the LATCH-type (ISOFIX) child
#
restraint system to both mounting brackets
in the vehicle.
59
of the