Changing The Remote Control Batteries - Grohe SENSIA IGS Operating Instructions Manual

OPERATING INSTRUCTIONS
10.16
Remote control:
low battery
CHANGE BATTERY
1. Remove cover
2. Replace batteries

Changing the remote control batteries

Message : " Remote control : low battery "
The LED display on the shower-toilet shows red.
There is a message on your remote control saying
" Remote control : low battery ". The unit takes four
conventional AAA 1.5-volt batteries.
Press " Service information " to switch to the instructions for
changing the batteries.
Remain in the direct proximity of the shower-toilet, no more
than two metres away.
Open the back of the remote control by lifting the cover
using the opening provided. Remove the old batteries and fit
four new ones. Make sure the polarity is correct. Close the
cover again.
If the remote control is only displaying the instructions for
changing the batteries and the display is no longer backlit,
you need to change the batteries immediately.
The shower-toilet can now only be operated using the controller.
Please dispose of the old batteries correctly. They may not
be disposed of with household waste.
262