System Fan Modules - HP ProLiant ML150 Generation 2 Maintenance And Service Manual

System Fan Modules

To remove the rear system fan module:
1. Complete the preparation procedures. Refer to "Preparation Procedures" earlier in this
chapter.
2. Open the bezel door. Refer to "Bezel Door" earlier in this chapter.
3. Remove the access panel. Refer to "Access Panel" earlier in this chapter.
4. Disconnect the rear system fan cable (1) from the system board.
NOTE: Front system fan cable connection shown for clarity (2).
Figure 2-9: Disconnecting the fan cables from the system board
HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide
HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 6/10/05 4:28 PM
Removal and Replacement Procedures
2-13