Stands - HP ProLiant ML150 Generation 2 Maintenance And Service Manual

Table of Contents

Stands

To remove the four stands from the chassis, one at a time:

1. Complete the preparation procedures. Refer to "Preparation Procedures" earlier in this

chapter.

2. Carefully place the server upside down.

3. Remove the T-15 Torx screw that secures each stand to the chassis (1).

4. Slide each stand towards the proper direction to detach it from the chassis (2) and pull it

off the base of the chassis (3).

Figure 2-49: Removing the stands from the chassis

To replace the stands, reverse steps 2 through 4.

HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide

HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 6/10/05 4:28 PM

Removal and Replacement Procedures

2-51

Table of Contents