Associating The Remote Control To The Machine; Servicing The Spark Plugs - Toro Pro Force 44553 Operator's Manual

1. Oil filter
2. Gasket
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter
4. Install the replacement oil filter to the filter
adapter, turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 2/3 to 1 turn
(Figure 24).
5. Fill the crankcase with the proper type of new
oil; refer to Servicing the Engine Oil (page
6. Run the engine for about 3 minutes, shut off the
engine, and check for oil leaks around the oil
filter.
7. Check the engine oil level and add oil if needed;
refer to Checking the Engine-Oil Level (page
23).
Associating the Remote
Control to the Machine
Important:
Read the entire procedure before
attempting the association procedure.
The remote control is associated to the machine
before leaving the factory. The remote control must
establish communications with the base unit before
the machine can be used. In situations where it is
necessary to reestablish remote control to machine
communications (e.g., introducing a new or spare
remote control to an existing base unit), you must
perform the following associating procedure.
Note:
Associating the remote control to a different
base unit will disassociate that remote control from
the original base unit.
1. Turn the key to the O
power.
2. Stand near the base unit in an unobstructed,
clear line of sight with the remote control in hand.
Figure 24
3. Adapter
(Figure 24).
position to turn off the
FF
3. Simultaneously press and hold the R
R and R
IGHT
will flash about once per second.
4. Continue to hold both buttons until the LED light
begins to flash about twice per second.
5. Release the buttons.
6. Press and hold the R
LED will flash about twice per second.
7. Turn the key to the R
g001056
to hold the R
will turn solid if the procedure is successful.
Note:
8. Release the R
The system is ready for use with that remote
control.
22).
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start

Servicing the Spark Plugs

Ensure that the air gap between the center and side
electrodes is correct before installing the spark plugs.
Use a spark plug wrench for removing and installing
the spark plugs and a gapping tool/feeler gauge to
check and adjust the air gap. Install new sparks plugs
if necessary.
Type: Champion® RC12YC, Champion® Platinum
3071 or equivalent
Air Gap: 0.76 mm (0.030 inch)
24
L buttons. The LED light
OTATE EFT
L
OTATE
position while continuing
UN
L button. The LED light
OTATE EFT
This could take up to 20 seconds.
L button.
OTATE EFT
Figure 25
5. Rotate right
6. Increase engine speed
7. Engine stop
OTATE
button. The
EFT
g029818