Mounting The Hitch To The Machine - Toro Pro Force 44553 Operator's Manual

DANGER
Battery electrolyte contains sulfuric acid
which is fatal if consumed and causes
severe burns.
• Do not drink electrolyte and avoid
contact with skin, eyes or clothing.
Wear safety glasses to shield your
eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is
always available for flushing the skin.
2. Attach the positive cable (red cable) to the
positive (+) terminal.
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.
3. Attach the negative cable (black cable) to the
negative (-) terminal of the battery.
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Install the battery cover and secure with the
clips.
2
Mounting the Hitch to the
Machine
Parts needed for this procedure:
1 Machine assembly
1 Hitch
2 Bolt (3/8 x 3 inches)
2 Flange nut (3/8 inch)
Procedure
1. Position the machine on a flat, level surface.
2. Insert the hitch tube into the frame brackets
(Figure 4). Secure the tube to the frame with 2
bolts (3/8 x 3 inches) and flange nuts (3/8 inch).
1. Frame brackets
3. Route the wire harness along the right side of
the hitch tube (Figure
1. Wire harness
4. Plug the harness clips into the holes in the side
of the hitch tube to secure it
5. Store the harness connector in the hitch tube
holster (Figure
9
Figure 4
2. Hitch tube
5).
Figure 5
2. Harness clips
(Figure 5).
6).
g020731
g020732