Diagnostic Light
The diagnostic light
(Figure
hour meter and indicates machine fault codes. After
you turn the key to the R
light will illuminate for 5 seconds, turn off for 5
seconds, and then begin flashing 3 times a second
until you push a button on the handheld remote. If the
light turns on for 5 seconds and then starts blinking 10
times a second (with or without a 5 second pause)
there is a fault with the machine; refer to
Fault Codes (page
31).
Note:
If you have a button pressed on the handheld
remote when you start the machine, the light will not
flash 3 times a second after it turns off for 5 seconds.
Figure 10
1. Diagnostic light
Specifications
Radio Specifications
Frequency
Max output power
10) is located below the
position, the diagnostic
UN
Checking
2.4 GHz
19.59 dBm
g029824
12