Synchronize The Remote Transmitter/Control Module - Toro 44538 Operator's Manual

1. Oil drain valve
6. Slowly pour approximately 80% of the specified oil
into the filler tube (Figure 18).
7. Check the oil level; refer to Checking the Engine Oil
Level.
8. Slowly add the additional oil to bring it to the Full
mark.
Changing the Oil Filter
Service Interval: Every 200 hours
Note: Change the oil filter more frequently when the
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Remove the old filter and wipe the filler adapter
gasket surface (Figure 20).
1. Oil filter
2. Adapter gasket
3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Figure 20).
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 2/3 to 1 turn (Figure 20).
Figure 19
2. Oil drain hose (not
included)
Figure 20
3. Adapter
5. Fill the crankcase with the proper type of new oil;
refer to Servicing the Engine Oil.
6. Run the engine for about 3 minutes, stop the engine,
and check for oil leaks around the oil filter.
7. Check the engine oil level and add oil if needed.
Synchronize the Remote
Transmitter/Control Module
If the remote is ever replaced, it will have to be
re-synchronized with the receiver.
1. Locate the yellow with black stripe wire which is
tucked into the wire harness tubing coming from
the 6 pin connector at the receiver (Figure 21). Pull
the wire out of the tubing.
1. Yellow with black stripe
wire
2. 6 pin connector
2. Rotate the engine ignition key to the "START"
position and quickly release it to the "ON" position.
This wakes up the receiver.
3. Ground the wire to the chassis. Touching the wire to
one of the engine starter motor mounting fasteners
is a good ground.
4. While grounding the wire to the chassis, push and
hold down any of the buttons on the remote.
5. While still pressing the remote button, remove the
wire from the ground.
6. Release the remote button.
7. Press one of the chute direction buttons to verify
that the re-synchronize was completed successfully.
8. Tuck the wire back into the tubing.
21
Figure 21
3. Engine starter motor