Automatically Setting The Remote Control - Philips SRU152/10 Instructions For Use Manual

SRU152.qxd 13-01-2005 12:30 Pagina 6
Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device, the remote control
can automatically search for the right code.
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU152 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
2
Then keep keys s and y on the SRU152
pressed simultaneously for five seconds, until
the green LED remains lit.
3
Press the Standby key of the SRU152 briefly.
– The SRU152 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the green LED
will flash.
4
When your TV switches off (stand-by),
you press the Standby key of the SRU152
twice within 1 second, to confirm.
– The SRU152 has now found a code that works on your TV.
5
Check if you can operate all functions on your TV with the SRU152.
• If this is not the case, you can redo the automatic setting.
The SRU152 will then search for a code that perhaps works
better.
– After the SRU152 has run through all the known codes,
the search will stop automatically and the green LED will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
6