Installing Your Computer System - Jaco One J1-10 Manual

Installing your computer system :

The JACO One Series Mobile Cart will support most PCs, Thin Clients, Laptops and All-In-One computer/LCD
systems however not all systems will fit and some may fit but will require too much power to operate using
our optional battery power system. Contact JACO Support if you have questions.
To install your PC or Laptop, unlock both key-locks at the rear of the top assembly as shown in the photo
below. Once unlocked, the top work surface can be pulled forward and removed from the Cart.
Once the work surface is removed, the open bay area (shown on left below) is available for installing your
computer or laptop. Route all cables needed for proper operation before installing the work surface and
locking in place for security. Shown below is an example of a small PC properly installed with all cables routed
neatly and organized. If using a laptop computer, simply open, place the laptop on the internal tray and allow
the display to protrude through the opening in the work surface.
Additional tips for proper computer installation:
SFF and Thin Client: insert inside the top bay so that the on/off power button is facing the side opening. This
will allow easy on/off of the unit when needed.
Laptop: Open the laptop, place inside the top bay. Neatly rout the AC brick and cables into the Top Bay with
the power cord plugged into the internal power strip. Install the work surface so that the laptop display
protrudes through the opening, lock the work surface in place for security.
All-In-One: The unit must have a 75mm or 100mm VESA pattern on the rear surface to mount to the J1-20
Mobile Cart. The hardware to mount the All-In-One is provided.
It is highly recommended that you use the Velcro adhesive patches included with all Mobile Carts inside the
accessories kit to hold the PC, Thin Client, or Laptop in place inside the Mobile Cart top assembly.
8