Installing Lcd Monitor; Installing Keyboard And Mouse - Jaco One J1-10 Manual

Installing LCD Monitor:

Installing Keyboard and Mouse :

When ordering your JACO Cart you have the option of including an
integrated mouse and keyboard. If you are adding your own mouse
and keyboard, they can be integrated as follows. It is most
important that the wires are routed out of the way of the sliding
keyboard tray. With each JACO Mobile Cart we include an
accessory pack that provides ty-wraps and Velcro pads along with
other helpful items for proper cable management. Use the Velcro
pads to fasten the keyboard to the keyboard tray and use the ty-
wraps to secure the cables.
9
Your J1-20 Mobile Cart ships with the LCD Stand in place but the
LCD is not attached. A Phillips Head or (if added security is
needed for the LCD) Torx Head driver is needed to attached the
LCD to the LCD Stand, 4 places. Both Phillips and Torx screws
are provided. It is recommended that one person hold the LCD
while a 2nd person inserts the hardware. Make sure all 4
screws are installed and tightened properly.
With the monitor and stand installed on the Cart, the LCD
power and signal cables can be installed. Route both cables
down through the cable management area of the stand as
shown to the left. Pull the cables into the Top Assembly and
attach to the PC or laptop computer that will be installed later.