Integrated Lfp Specification; Integrated Lfp Agency Certification - Jaco One J1-10 Manual

3. Wake-up the Battery System
Mobile Cart into any standard 120VAC wall outlet to "Activate" the Battery Power System.
4. Unplug the power cord
completely so that the status LED readout will be properly calibrated. If possible, power up the
computer and LCD or the laptop to help drain the battery system.
5. Allow time to Calibrate
below, needs to learn or calibrate as the power system charges from fully drained to fully charged.
Leave the Mobile Cart plugged into the wall outlet until all 5 status LEDs are showing green indicating
that the batteries are fully charged. This step could take up to 4 hours but it is best to allow the charge
to continue over night when possible.

Integrated LFP Specification:

 Model: JPS250 or JPS500
 Battery: Lithium Iron Phosphate also known as LiFePO4 and LFP
 AC Input: 100vac to 240vac
 Input Current: 3.5 amps
 Frequency: 47 to 63 Hz
 Output Voltage: 120VAC /60Hz standard
 Output Current: 1.5A @ 120VAC continuous
 Output Power: 180 watts continuous
 Operating Temperature: 32 to +95 Degrees Fahrenheit
 Non-Operating Temperature: 0 to 120 Degrees Fahrenheit
 Electronics Box (Inverter/Charger Unit) Dimensions: 10.6" (L) x 9.65" (W) x 2.2" (H)

Integrated LFP Agency Certification:

The JACO Integrated LFP Battery Power System, Inverter/Charger Assembly has been tested and
approved to the following agency certifications - IEC 60601-1/A2: 1995 & IEC60950-1:2005
– Plug the recharge power cord that is hanging from the back of the
– This step is necessary as you need to let the battery system drain
– The status gauge readout at the front top of the Mobile Cart, as shown
16