Hot-Swap Lfp Battery System - Jaco One J1-10 Manual

Hot-Swap LFP Battery System

To insert the Power Blade Battery Pack into the Cart Controller, simply hold by the integrated handle
and insert into the Cart Controller using the side guides for alignment. As you push the Power Blade
Battery Pack into position, make sure to push down to engage the connector. To remove, grab the
handle and pull the Power Blade Battery Pack up and out.
Note that when two Power Blade Battery Packs are
installed in the Controller, you will notice that one
rear facing status LED will blink every 6 seconds. This
is normal and used as an indicator as to which Power
Blade Battery Pack is providing power. If two
charged Power Blade Battery Packs are installed,
power will switch instantly from one to the other
when one Power Blade Battery Pack is removed.
LED Charge Capacity Status:
The Power Blade Battery Pack ports on the Mobile Cart are labeled as Battery 1 and Battery 2. Each
port has two LED indicators that show approximately how much battery charge is remaining. The LED
indicators are located at the front and rear of the Cart. This simple LED readout reports approximate
battery charge as follows...
NOTE: If both Power Blade Battery Packs show
This will continue for several minutes. Replace at least one with a charged Power Blade Battery Pack
within this warning period to prevent the on-board computer & monitor from shutting down.
* 100% to 21% Charge on Battery Pack - Solid
* 20% to 11% Charge on Battery Pack - Solid
* 10% to 1% Charge on Battery Pack - Blinking
* No Charge Remaining - Solid RED LED
RED (fully drained), the Cart will "beep" as a warning.
Green LED
Amber LED
RED LED
22