Integration & Operation; Unpacking & Assembly; Changing The Height Position & Lift Resistance - Jaco One J1-10 Manual

Integration & Operation
Unpacking & Assembly:
Your JACO Mobile Cart is delivered on a pallet and unpacking is a two-person task, please plan accordingly. Use
caution when removing any additional containers that may have shipped on top of the Mobile Cart pack. Once
unpacked, there will be minimal assembly required depending on the Mobile Cart model and options you have
ordered. Due to the shipping container, the optional LCD (J1-20 Cart Models) and several of the optional
Scanner Mounts are not able to be attached at our factory. Instructions for assembly are below.
Changing the Height Position & Lift Resistance:
Your JACO Mobile Cart is height adjustable for proper ergonomics when
used in a standing or sitting position. To change the height, place the
palms of your hands on the left and right sides of the work surface and
on the right side, squeeze the release lever by pulling it upward. This
will free the internal locking piston and will allow you to pull the Cart top
up or push it down and offers a total of 13.5" of travel. Release the lever
when the cart is in the desired position.
You may also need to adjust the lift resistance. If the force needed to
adjust the height of the Cart is too much or not enough, you may fine
tune this setting by inserting a 5/16" Allen wrench into the opening on
the left side of the Carts Upper Post. First position the height of the Cart
so that the middle bars are level to the floor then make sure the wrench
is pushed into the Allen head adjustment screw. Rotating clockwise will
decrease the internal force, counter clockwise will increase this force.
This is for fine tuning only, consult with your local Sales Representative
with questions.
7