Integrated Lfp Set-Up - Jaco One J1-10 Manual

Right side view
4. Cooling Fan*
5. E-Locking power
6. Power model selector
7. DC power (to battery)
8. USB (Firmware update)
9. LED display
* The Cooling Fan (item #4 above) will power on whenever the unit is plugged in for recharge. The fan will run
from a continuous, slow idle speed, to full speed, in order to minimize fan noise in response to rising internal
temperatures. The fan will also power on whenever the On/Off AC Outlet Switch (item #2 above) is in the ON
position regardless of recharging status.

Integrated LFP Set-up:

The JACO Battery System is shipped in "cut-off" mode to prevent power drain during shipping. Follow the steps
below to activate the power system and calibrate the status LED readout properly.
1. Integrate your PC or Laptop
take the time to properly install the computer system (details on page 8).
Route all cables neatly and use the ty-wraps and Velcro pads provided in the Cart Accessory kit.
2. Turn on power to the AC Outlets
position. This switch can be accessed by opening the rear enclosure door, a blade screwdriver will be
needed. The power switch is located on the left side of the inverter/charger assembly as shown below.
15
– After your Mobile Cart is unpacked and ready to go, you should
– Push the AC Switch shown as item 2 on page 14, to the ON
4
5 6 7
9
8