Handling And Use; Display Charge Level; Switching The Hands-Free Set On And Off - Silvercrest SBTF 10 D4 Manual

CAUTION
► Alternatively, you can also charge the battery on an
external USB mains adapter. Use only USB mains
adapters with an output voltage of 5 V and an output
current of at least 1 A to charge the battery. Use the
supplied charging cable
► Due to the high power consumption, the battery should
not be charged on a computer.

Handling and use

This section provides you with important information on
handling and using the appliance.

Display charge level

You can also check the charge level of the hands-free set
when it is not charged or while it is being used for charging.
♦ Press the button
show the current charge level of the hands-free set
for a few seconds.
LED display
All LEDs are on
Three LEDs are on
Two LEDs are on
One LED is on
One LED is flashing
All LEDs off
Switching the hands-free set on and off
♦ Press the
hear a short, high-pitched beep and the operating/
charging LED
now in standby mode. The operating LED now flashes
blue every 10 seconds.
NOTE
► If no mobile phone is paired with the hands-free set, it
automatically switches into pairing mode after a short
time.
SBTF 10 D4
briefly. The charge level LEDs
button for about 3 seconds until you
lights up blue. The hands-free set is
for this.
Charge level
76 - 100 %
51 - 75 %
26 - 50 %
11 - 25 %
1 - 10 %
0 %
GB │ MT │
63 ■