Handling And Use; Switching The Hands-Free Set On And Off - Silvercrest SFA 40 A1 Operating Instruction

Bluetooth 4.0 hands-free kit
Hide thumbs Also See for SFA 40 A1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 31
CAUTION
Only charge the battery in the hands-free set, as the cor-
responding charging electronics are built into the device .
Charge the battery only when the motor is running to pre-
serve your car battery .
Do not charge the battery while the hands-free set is attached
to the sun visor as the connecting cable may interfere with the
operation of the vehicle .
Alternatively, the battery can be charged on a PC or an exter-
nal mains adapter . You will need a connecting cable with a
suitable USB connection .

Handling and use

This section provides you with important information on handling and
using the device .

Switching the hands-free set on and off

Press the multifunction button
until you hear a high-pitched beep and the operating LED
lights up blue . The hands-free set is now in standby mode . The
operating LED now flashes blue every 6 seconds .
NOTE
If no mobile phone is paired with the hands-free set, it
switches after a short time into pairing mode .
Press the multifunction button
onds to switch off the hands-free set . You will hear a low beep
and the operating LED lights up briefly orange before going out
completely . The hands-free set is now switched off .
38 
GB │ IE
for about 3 seconds
again for about 5 sec-
SFA 40 A1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents