KVH Industries TracVision M7 Replacement Instructions Manual page 4

TracVision M7
Main PCB Replacement Instructions
4
f. Disconnect the Molex connectors from the main PCB
(see Figure 3 on page
g. Using a #1 Phillips screwdriver, remove the nine screws
securing the main PCB to the antenna frame
(see Figure 3 on page
h. Remove the faulty main PCB.
i. Reverse this process to install the replacement main
PCB. (If you replaced an old version PCB, as identified
in Step 1d, be sure to connect the azimuth and elevation
wires to the new PCB as shown in
reinstall the radome and reconnect power to the
TracVision system.
Figure 4 Gyro Connections from Old Version PCB to New Version PCB
Small PCB
Not Used
Elevation
NOTE: Be sure to remove the labels you applied to the wires in
Step 1e.
3).
3).
Figure 4.) Then
Azimuth