Using Wps Pin Mode To Connect To A Network - Epson FF-680W User Manual

Note: If the ! error light turns on, the connection failed. Press the
restart the scanner and router, and repeat these steps.
4. Select the link below to set up network scanner. You must set up network scanning to connect your
computer and wireless scanner.
Parent topic:
Related tasks
Setting Up Network Scanning

Using WPS PIN Mode to Connect to a Network

If you have a WPS-enabled wireless router that supports PIN mode, you can use Wi-Fi Protected Setup
(WPS) PIN mode to connect your scanner to the network.
1. Open the scanner's input tray.
2. Press and hold the
for at least three seconds, then release them when the
Note: The scanner enters discovery mode for 2 minutes.
3. Use your computer to enter the PIN code 01234565 into the WPS PIN number setting in the wireless
router within 2 minutes.
Note: If you do not enter the code within 2 minutes, repeat steps 1 through 3.
The Wi-Fi and
Wi-Fi light on the scanner stays on, the scanner is connected to the network.
Note: If the ! error light turns on, the connection failed. Press the
restart the router, and repeat these steps.
4. Select the link below to set up network scanning. You must set up network scanning to connect your
computer and wireless scanner.
Parent topic:
Related tasks
Setting Up Network Scanning
Wi-Fi Protected Setup (WPS)
Wi-Fi button and the
AP mode lights flash alternately while establishing the connection. When the
Wi-Fi Protected Setup (WPS)
stop button to clear the error,
Wi-Fi connect button on the scanner simultaneously
Wi-Fi light flashes blue.
stop button to clear the error,
18