Canon Inner Finisher-D1 Installation Procedure page 7

Installation Procedure > Preparation at the Host Machine
10)Lift up the sensor flag (for the delivery tray 1 full detection) as shown in the figure and
remove it.
(Removed sensor flag is no longer reused.)
11) Remove the sensor flag holder.
(Removed sensor flag holder is no longer reused.)
• 1 hook
Installation Procedure > Preparation at the Host Machine
12) Remove the sensor flag (for the delivery tray 2 full detection) if there is.
(Removed sensor flag is no longer reused.)
F-1-12
NOTE:
Bend the sensor flag and dismount its shaft at the front end. Then remove the
F-1-13
shaft downward at the rear end.
7
F-1-14
7