Canon Inner Finisher-D1 Installation Procedure page 18

Installation Procedure > Installing the Inner Finisher in the Host Machine
21) Remove 2 screws to remove the blindfold cover from the reader front cover.
Using removed 2 screws, fix the operation sub cover.
x2
x2
Installation Procedure > Installing the Inner Finisher in the Host Machine
22) Restore the reader front cover
• 2 screws (RS tightening, M3x6; removed at step 20)
NOTE:
First, set the right side of the reader front cover.
Next, slightly bend the reader front cover and set the left side releasing the claw of
the operation sub cover from the operation panel.
23) Close the ADF (or copy board cover).
24) Stick the blindfold label (white) on the existing hand label.
Then set the inner finisher to the host machine and close the finisher front cover.
F-1-44
18
F-1-45
F-1-46
18