Summary of Contents for Billy Goat Z FORCE FZ1300H
Page 1
Z FORCE BLOWER Owner’s Manual Patents Pending FZ1300H BILLY GOAT Z FORCE BLOWER Owner's Manual *JRCO Universal Mount Not Included* Contact your Billy Goat Dealer or visit http://jrcoinc.com/ for a list of JRCO Products Part No 442503 Form No F081512A...
Z FORCE BLOWER Owner’s Manual CONTENTS SPECIFICATIONS _______________________ SAFETY INSTRUCTIONS AND WARNINGS_________________________________4-5 INSTRUCTION LABELS PACKING CHECKLIST ASSEMBLY OPERATION __ 9 MAINTENANCE AND WARRANTY INFO ____ TROUBLESHOOTING AND WIRING DIAGRAM ______________________________11 ILLUSTRATED PARTS LIST PARTS LIST MAINTENANCE RECORD________________________________________________14 Part No 442503 Form No F081512A...
This symbol indicates that this manual and the engine manufacturer’s manual should be read carefully before assembling, operation, or servicing this equipment. ® This symbol indicates important information that will prevent damage to your BILLY GOAT Z FORCE Blower. This symbol indicates the engine oil level should be checked before operating this equipment.
Page 5
Z FORCE BLOWER Owner’s Manual DO NOT run this equipment indoors or in any poorly ventilated area. Refueling outdoors is recommended. DO NOT refuel this equipment while the engine is running. Allow engine to cool for at least two minutes before refueling.
Z FORCE BLOWER Owner’s Manual INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT Z FORCE Blower. If any labels are damaged or missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part numbers are provided for convenience in ordering replacement labels.
These items should be included in your carton. If any of these parts are missing, contact your dealer. ® Your BILLY GOAT Z FORCE Blower was shipped in one carton, completely assembled. Mounting hardware can be found on the attachment points on the frame.
Z FORCE BLOWER Owner’s Manual ASSEMBLY 1.Follow the steps in figures A and B, then securely tighten all hardware shown. 2.Connect spark plug wire on the blower. Figure A Figure B Make sure your JRCO bar is attached to your mower. Connect the rear portion of the wiring harness to the Then replace the mounting bracket with the bracket mower battery by attaching the red wire to the positive...
BLOWING OPERATION Your Billy Goat Z Force blower is equipped with a motorized air director nozzle to allow the operator to direct the air stream by rotating left or right as required to assist in moving debris. This feature is extremely useful when having to move debris in various directions.
Z FORCE BLOWER Owner’s Manual TROUBLESHOOTING Problem Possible Cause Solution Abnormal vibration. · Loose or out of balance impeller. · Check impeller and replace if required. · Debris in impeller. · Clear debris with compressed air or a backpack blower (see below pictures).* ·...
Z FORCE BLOWER Owner’s Manual PARTS LIST Item No. Part No. Description Item No. Part No. Description 442501 LABEL LOGO FZ 8171004 WASHER 3/8" FC 442500 LABEL WARNING FZ 440176 WASHER 1.5 OD X .453 ID X .5 THK 442600 FRAME WA FZ W/LABELS 8041007 SCREWCAP 1/4"-20 X 1 1/4"...