Page 1
Patents Pending Z FORCE BLOWER Owner's Manual FZ1301H Beginning Serial #: 110315001 *JRCO Universal Mount Not Included* Contact your Billy Goat Dealer or visit http://jrcoinc.com/ for a list of JRCO Products This unit will need to be purchased with either the...
FORCE Z BLOWER Owner’s Manual CONTENTS SPECIFICATIONS SAFETY INSTRUCTIONS AND WARNINGS INSTRUCTION LABELS PACKING CHECKLIST ASSEMBLY OPERATION MAINTENANCE AND WARRANTY INFO TROUBLESHOOTING AND WIRING DIAGRAM ILLUSTRATED PARTS LIST PARTS LIST MAINTENANCE RECORD Part No 442509 Form No F110315B...
This symbol indicates that this manual and the engine manufacturer’s manual should be read carefully before assembling, operation, or servicing this equipment. ® This symbol indicates important information that will prevent damage to your BILLY GOAT Z FORCE Blower. This symbol indicates the engine oil level should be checked before operating this equipment.
Page 5
FORCE Z BLOWER Owner’s Manual DO NOT run this equipment indoors or in any poorly ventilated area. Refueling outdoors is recommended. DO NOT refuel this equipment while the engine is running. Allow engine to cool for at least two minutes before refueling.
INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT Z FORCE Blower. If any labels are damaged or missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part numbers are provided for convenience in ordering replacement labels.
These items should be included in your carton. If any of these parts are missing, contact your dealer. ® Your BILLY GOAT Z FORCE Blower was shipped in one carton, completely assembled. Mounting hardware can be found on the attachment points on the frame.
FORCE Z BLOWER Owner’s Manual ASSEMBLY 1.Follow the steps in figures A and B, then securely tighten all hardware shown. 2.Connect spark plug wire on the blower. Step 1 Step 2 Make sure your JRCO bar is attached to your mower. Connect either the Foot Pedal switch (P/N 442607 or the Then replace the mounting bracket with the bracket Hand switch (P/N 442608) to the unit and battery.
BLOWING OPERATION Your Billy Goat Z Force blower is equipped with a motorized air director nozzle to allow the operator to direct the air stream by rotating left or right as required to assist in moving debris. This feature is extremely useful when having to move debris in various directions.
FORCE Z BLOWER Owner’s Manual TROUBLESHOOTING Problem Possible Cause Solution Abnormal vibration. · Loose or out of balance impeller. · Check impeller and replace if required. · Debris in impeller. · Clear debris with compressed air or a backpack blower (see below pictures).* ·...
FORCE Z BLOWER Owner’s Manual PARTS LIST FORCE Z Item No. Part No. Description Item No. Part No. Description 442501 LABEL LOGO FZ 8171004 WASHER 3/8" FC 442500 LABEL WARNING FZ 440176 WASHER 1.5 OD X .453 ID X .5 THK 442600 FRAME WA FZ W/LABELS 8041007...