Omron EQUO Series User Manual page 51

When the measured value update cycle is set for 10 seconds, the measurement is performed
for 10 times every 1 second. When processing mode (MEAS) is set for AVE/MAX/MIN, the
maximum/minimum/average values of each 6 measured values are given as the measured values.
When processing mode is set for MAX/MIN/AVE, "MAX", "MIN" and "AVE" are turned ON at
the lower left of the display.
Note
 When MAX/MIN/AVE is specified as processing mode and the operation mode is switched
from "SCL" to "RUN", the display may keep showing "-----". This is because the unit waits for
the necessary data to be accumulated. The estimated time is as follows:
ZN-DPX21-S
ZN-THX21-S, ZN-THX11-S
(3) Measurement operation mode (MODE)
Specifies the mode of measurement operation.
Measurement
operation mode
NORM
NET
SLEEP
PD-S
DPX21 THX21
Setting range (selection type):
NET / SLEEP / PD-S
Initial value:
NET
THX11
Setting range (selection type):
NORM / SLEEP
Initial value:
NORM
Note
 Change the operation mode with the MODE key after changing the measured operation
mode by confirming it with the SET/REC/STOP key. The unit is reset and restarted.
Approx. 1 sec.
Approx. (time that has been set with CYCLE – 10) sec.
Normal mode
Network connection mode:
The unit and PC will be connected via a network to record measured
data. Remote setting is also available.
Sleep mode:
The unit operates in power saving mode. The CPU enters into standby
state except when measuring through measurement value update
cycles.
As the Ether port also is on standby state, network connection is not
available.
If SDISP, which is described later, is OFF, the display will not be shown.
Even if the display is not shown, you can press any key to resume the
display. However, when there is no key operation for 5 seconds, the
display will disappear again.
Operating the unit in sleep mode is recommended for battery drive.
Air Particle Sensor connection mode:
Connect an Air Particle Sensor ZN-PD-S via LAN cable to record
the values measured with the Air Particle Sensor in the internal memory
of the unit.
4-6
4. Setting the Unit (Unit Operation)
Operation