Omron EQUO Series User Manual page 36

(4) Changing IP address (from factory default 192.168.0.20 to 192.168.0.21)
Display (upper
line/ lower line)
IP
DISP
↓
▼ or ▲ key
IP 1
192
↓
▼ key
IP 2
168
↓
▼ key
IP 3
0
↓
▼ key
IP 4
20
↓
SET/REC/STOP key
IP 4
020
↑ blinks
↓
▼ or ▲ key
IP 4
021
↑ blinks
↓
SET/REC/STOP key
IP 4
21
↓
▼ key
Similarly, check that SUB1 to SUB4 are 255, 255, 255 and 0 respectively, and set them. After
completion of setting SUB1 to SUB4, press the MODE key. "RESET" is displayed and the
system is restarted.
Display the first segment of IP address. Press the ▼ or ▲ key until "IP
1" is displayed in the upper section.
Check that "192" is displayed in the lower section and then press the ▼
key. If "192" is not displayed, change the value referring to the example
of changing "IP 4" as described later.
Check that "168" is displayed in the lower section and then press the ▼
key. If "168" is not displayed, change the value referring to the example
of changing "IP 4" as described later.
Check that "0" is displayed in the lower section and then press the ▼
key. If "0" is not displayed, change the value referring to the example of
changing "IP 4" as described later.
To change the value at the lower section to 21 that is different from the
displayed value, press the SET/REC/STOP key.
The numeric value blinks. Press the ▼ or ▲ key to set the value to 21.
Press the SET/REC/STOP key to confirm the value. Blinking stops.
To further check and change subnet mask, press the ▼ key to display
"SUB1" in the upper section.
3-10
3. Check and Preparation
Operation