Zn-Thx21-S / Zn-Thx11-S - Omron EQUO Series User Manual

5.3.2 ZN-THX21-S / ZN-THX11-S

Measured
Measured humidity
Number of writings
Current time
Measured
Temperature
Measured humidity
Humidity threshold
Returns to the temperature/humidity display.
Note
 "REC" turns ON during data recording.
 "ALM" turns ON when the measured value exceeds the upper limit threshold value or when
the measured value falls short of the lower limit threshold value and the alarm output is
turned ON. When the alarm hold has been set, the alarm output state is maintained and
"ALM" keeps turned ON even if the alarm state is released. Hold the MODE key to stay
alarm.
 "MAX", "MIN" and "AVE" turn ON when processing mode has been set to MAX, MIN and
AVE. They are not displayed in "NORM".
Temperature measurement value (°C) is displayed in the upper line and
humidity measurement value (%) is displayed in the lower line.
If computation for the measured value has been set, the value after
computation is displayed with "MAX"/"MIN"/"AVE" and "RUN" turned ON.
If adjustment has been set, the value after adjustment is displayed with
"SCL" and "RUN" turned ON.
The number of writings to the internal memory since the recording start
is displayed in the upper line, the current time is displayed in the lower
line.
When measured data is written in the internal memory per time cycle
specified by measurement update cycle (CYCLE), the value in the upper
line increases by 1. When the internal memory becomes full, "FULL" is
displayed. If the data accumulated in the internal memory is written to
the SD memory card due to an event such as the SET/REC/STOP key
having been pressed during recording, the value will be cleared to 0.
Temperature measurement value (°C) is displayed in the upper line and
temperature threshold value is displayed in the lower line. The threshold
value is displayed alternately between upper limit (Hi) and lower limit
(Lo).
If computation has been set, a temperature measurement value after
computation is displayed with "MAX"/"MIN"/"SCL" and "RUN" turned ON.
If adjustment has been set, a temperature measurement value after
adjustment is displayed with "SCL" and "RUN" turned ON.
Humidity measurement value (°C) is displayed in the upper line and
threshold value is displayed in the lower line. The threshold value is
displayed alternately between upper limit (Hi) and lower limit (Lo).
If computation has been set, a humidity measurement value after
computation is displayed with "MAX"/"MIN"/"SCL" and "RUN" turned ON.
If adjustment has been set, a humidity measurement value after
adjustment is displayed with "SCL" and "RUN" turned ON.
5-4
5. Measurement and Recording (Unit Operation)