Ford 1833 Series User Manual page 113

rh
Reverse, high range
RL
Reverse, low range
rm
Reverse Manoeuvring Mode.
This shall be used while coasting only.
AL
Air pressure low: A separate air tube
is available for the automated transmission in
your vehicle. If the air pressure in the trans-
mission air line goes below 5.8 bar, AL warning
shall be displayed.
WARNING
 Attempting to shift while the air pressure is
low may cause shifting of the transmission
to neutral. In this case, exhaust brake shall
not be active.
 When the air pressure drops, it is not pos-
sible to disengage the clutch.
CC
Clutch Control
Clutch position cannot be calculated by the
system.
CL
Clutch is overloaded.
This is displayed when you attempt to take off
the vehicle with a gear higher than required in
manual mode. Select a lower gear and take off
the vehicle in this condition.
Clutch lining wear
Clutch lining wear has reached limit value. Ple-
ase visit a Ford Trucks authorized dealership in
the shortest possible time.
Electronic fault.
Communication error between the instrument
cluster and transmission electronic control unit.
Please visit a Ford Trucks authorized dealers-
hip in the shortest possible time.
Accelerator Pedal:
Remove your foot from the accelerator when
this warning is displayed. If the warning is not
removed, there is a fault in the system. Please
visit a Ford Trucks authorized dealership.
Shift to neutral.
111
OPERATION
Shifting
When the vehicle is left in D while being par-
ked for a long time, this applies a load on the
clutch. When NS warning is displayed, trans-
mission control unit indicates that the vehicle
is left in D without moving for a long time. Shift
to neutral.
Transmission oil temperature has reached
upper limit. Stop the vehicle. Please contact a
Ford Trucks authorized dealership.
4