Electrical Safety - Black+Decker PD1202N Manual

Never attempt to charge nonrecharge-
u
able batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed
for a specific voltage. Always check
that the mains voltage corresponds
to the voltage on the rating plate.
Never attempt to replace the charg-
er unit with a regular mains plug.
Symbols on the charger
Read all of this manual carefully
before using the appliance.
#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
x
The charger automatically shuts
off if the ambient temperature
becomes too high. The thermal
cut out operates only once and
then requires complete replace-
ment.
(Original instructions)
$
The charging base is intended
for indoor use only.
Features
This appliance includes some or all of the following features.
1. On/off power switch
2. Removable hose/handle
3. Locking ring
4. Hose
5. Filter cleaning wheel
6. Transparent door
7. LED charging indicator
8. Door latch
9. 2-in-1 combi nozzle accessory
10. Accessory clip
11. Charging inlet
Assembly
Mounting accessories (fig. A)
The 2-in-1 combi nozzle (9) has a brush that can be folded
forward for dusting and upholstery cleaning.
To fit an accessory press the accessory clip (10) and slide
u
the accessory onto the handle (2).
To remove an accessory, press the accessory clip (10)
u
and remove the accessory.
The handle (2) can be removed from the hose (4) allowing the
accessories (9) to be connected directly to the hose cuff (13)
when required.
To remove the handle:
Unclip the handle (2) from the appliance.
u
Rotate the locking ring (3) anti-clockwise to release the
u
clips.
Pull the hose (4) away from the handle (2).
u
Fit the accessory directly to the hose cuff (13).
u
To refit the handle:
Remove the accessory from the hose.
u
Push the hose (4) into the handle (2). Rotate the locking
u
ring (3) clockwise until it clicks into place.
ENGLISH
5