WARNING
This motor spindle is not a hand tool. It is designed to be used on CNC machines or special purpose machines.
①
②
Do not touch the cutting tool while it is running. It is very dangerous.
Wear safety glasses, dust mask and use a protective cover around the motor spindle whenever the motor spindle
③
is rotating.
Never connect, disconnect or touch the Power Cord Plug and Motor Cord Plug with wet hands. This may cause an
④
electric shock.
Never operate or handle the motor spindle until you have thoroughly read the owner's manual and safe operation
⑤
has been confirmed.
1) To prevent injuries / damages, check the motor spindle and cutting tool for proper installation, before operating
the motor spindle.
2) Before disconnecting the motor spindle, always turn the control power off and turn the compressed air supply
to the CONTROLLER off. Then it is safe to remove the motor spindle.
When installing a tool, tighten the collet correctly and check again the collet and collet nut before use. Do not over-
⑥
tighten the collet. This may cause damage to the spindle.
Do not use bent, broken, chipped, out of round or sub-standard tools as they may cause shatter or explode. Tool
⑦
with fractures or a bent shank will cause injury to the operator. When using a new tool, rotate it in a low speed and
increase speed gradually for safety.
47