Advertisement
9 . CONNECTION OF MOTOR CORD AND AIR SUPPLY
9 - 1 Connection of the Motor Cord
CAUTION
・
Before connecting to the Motor Cord Plug, make sure the Main Power Switch on the CONTROLLER is turned OFF. If the Main
Power Switch on the CONTROLLER is ON while connecting the Motor Cord Plug, damage may cause to the CONTROLLER.
Install the connector cover (protective cap etc.) to prevent damage or contamination to the Motor Cord Plug when not in use.
・
9 - 1 - 1 Connection of the Motor Cord <EMCD-BM 3 -
The following instructions are for the spindles listed below only:
(BM- 319 / BM- 319 C / BM- 319 F / BM- 319 FC / BM- 320 / BM- 320 F / BM- 322 / BM- 322 FR / BM- 322 FL / BM- 322 FS / BM- 325 ）
① Remove the Protective Cover of the Motor Cord.
□ M>
Protective Cover
Removal
Fig. 25
69
Advertisement
