Advertisement
WARNING
Do not exceed the maximum recommended allowable tool speed. For your safety, use speeds below the maximum
⑧
allowable speed.
Do not apply excessive force. This may cause tool slippage, tool damage, injury to the operator or loss of
⑨
concentricity and precision.
CAUTION
Do not drop or hit this motor spindle, as shock can damage to the internal components.
①
Be sure to clean the collet and collet nut, the inside of the spindle before replacing the tool. If ground particles or
②
metal chips stick to the inside of spindle or the collet, damage to the collet or spindle can occur due to the loss of
precision.
When cleaning a motor spindle, stop the motor spindle and remove debris with a soft brush or a cloth. Do not blow
③
air into the dust proof cover area (refer to section 6 - 2 " Outside view ") with compressed air as foreign particles
or cutting debris may get into the ball bearing.
Always clean the tool shank before installing the tool in the spindle.
④
When sizing the correct collet size to the tool shank diameter, a tolerance of + 0 ~ - 0.01mm is strongly
⑤
recommended. A tool shank within the + 0 ~ - 0.1mm range is mountable, however, this may cause poor
concentricity and or insufficient tool shank gripping force.
48
Advertisement
