Advertisement
⑥ Always operate tools within the allowable recommended speed of the tools. Use of a tool outside of the allowable speed of the tools
could cause damage to the spindle and injury to the operator.
⑦ Keep the tool shank and collet clean. If contaminants are left in the collet or collet nut, excessive run-out will cause damage to the tool
and or spindle.
⑧ Do not strike or disassemble the motor spindle.
⑨ Please set the tools to minimize the overhang amount. 13mm is the maximum amount of overhang to maintain high accuracy and
safety.
Table 6. Overhang and Speed
Overhang
(mm)
20
25
50
N = Max. Operating Speed with 13mm overhang.
86
Max. Speed (min
-1
)
N x 0.5
N x 0.3
N x 0.1
13
Fig. 45
Advertisement
