Installation - BWT Multipur AP Series Installation And Operating Manual

> 400 mm > 400 mm > 400 mm > 400 mm > 400 mm
min. DN 50 min. DN 50 min. DN 50 min. DN 50 min. DN 50
Druck-Entlastungs-
schlauch einstecken
> 20 mm > 20 mm
> 20 mm > 20 mm > 20 mm
> 1 m > 1 m
> 1 m > 1 m > 1 m

Installation

Installation
Installation Installation Installation
Install the backwash filter horizontally in the cold
water line in the flow direction. (Observe the flow
direction arrow on the filter casing.)
Screw on the waste water connection, either for
pipe or for hose. Connect the drain line .
If desired, an external fault signal issued by a
potential-free changeover contact can be con-
nected to the building automation system termi-
nals.
Put in pressure relief hose from the solenoid valve
in the upper cutout of the drain connection
respectively in the sloping drill hole of the hose
liner.
A mains power outlet must be available in the
immediate vicinity (max. 1.2 m away).
Caution: Do not plug in the control unit at this Caution: Do not plug in the control unit at this Caution: Do not plug in the control unit at this Caution: Do not plug in the control unit at this Caution: Do not plug in the control unit at this
time. time.
time. time. time.
Commissioning Commissioning Commissioning
Commissioning Commissioning
Check that the filter and flushing water pipe have
been properly installed.
Slowly open the stop valves up- and downstream
min. DN 50 min. DN 50 min. DN 50
min. DN 50 min. DN 50
of the filter. Deaerate the pipework at the next bleed
point downstream of the filter, and drain water
briefly.
Check the seals of the installation and filter for
leaks.
3 3 3 3 3 Insert the cable plug connector of the transformer
into the socket (24V
Plug in transformer with plug (3 3 3 3 3 ). The first back-
washing cycle is performed automatically (during
backwashing the illuminated segments on the dis-
play turn).
The factory setting
24 V 24 V 24 V
24 V 24 V
24V). 24V 24V 24V
7 8
(7 days) appears.
GB GB GB GB GB
13 13 13 13 13