Servo Monitor; Setting Procedure - FUTABA T12Z Software Update

Servo monitor

1. When the cursor lever is pushed, the normal channel
display and multiprop channel display are switched.
<Normal channel display>
<Multiprop channel display>
LOGIC SWITCH [Model Menu]
The logic switch function lets you turn operation on and off by
combining multiple switches. For instance, "Turn on the
function when 2 switches are turned on simultaneously" can be
set.
·Up to 4 switches can be combined.
·Up to 10 circuits can be used with the condition switches and
up to 8 circuits can be used with the ON/OFF switch of each
mixing function, except airplane snap roll.
<Mixing ON/OFF switch display>
(example of program mixing)

Setting procedure

1. Use the cursor lever to move the cursor to the switch
display of the function you want to set. Push the DATA
button.
2. The switch selection screen shown below is displayed.
<Mixing ON/OFF switch display>
(example of program mixing)
3. Use the cursor lever to move the cursor to the switch
mode. Use the dial to select the single switch mode or
logic switch mode, and push the DATA button. The single
switch mode is used with individual switches, the same
as in the past. When switched to the logic switch mode,
the switch mode and switches are displayed as shown
below. ON/OFF is determined by the combination of the
switch and logic mode displayed at the top and bottom.
Switch mode
Switch
Switch state display (INH, ON, OFF)
(Condition switch: ON and OFF)
4. Use the cursor lever to move the cursor to the logic
mode. Use the dial to select the logic from the three
types AND, OR, and Ex-OR, and push the DATA button.
Logic operation is shown in the table at below right. For
AND, both switches are ON, for OR, either one of the
switches is ON, and for Ex-OR, when the two switches
are in different states, the result is ON.
5. Use the cursor lever to move the cursor to the top or
bottom switch mode. Use the dial to select the logic
switch mode, and push the DATA button. Switch display
is added to each. A combination of up to 4 switches can
be registered in this manner. When 3 or more switches
are registered, the left and right switch combinations
surrounded by the frame are judged first. Next, the
combination in the judged frame are judged by the logic
displayed at the far right side. Finally, ON/OFF is
decided.
Judgment(1)
*In the above example, first SW-A and SW-B are judged by AND
condition and then SW-C and SW-D are judged by AND condition.
Lastly, the result of judgment of the SW-A and SW-B judgment result
and SW-C and SW-D judgment result by OR condition becomes the
final result. In this case, when SW-A and SW-B are simultaneously ON
or SW-C and SW-D are simultaneously ON, the result is ON.
Restrictions:
1. Logic switches can be used in mixing the ON/OFF
setting with up to 8 circuits for each condition. In
condition switching, it can be used with up to 10 circuits.
When logic switches exceeding the maximum settable
value are selected, an error message is displayed.
Release the unnecessary logic switches and then
reselect.
- 12 -
Mode selection
Judgment(2)
Judgment(3)