Cisco ONS 15600 Installation Instructions Manual page 12

NTP- E8 Replace the Rear Cover
Always use the supplied ESD wristband when working with a powered ONS 15600. Plug the wristband
Caution
cable into either the ESD jack located on the lower-left outside edge of the bay assembly, or the other
ESD jack located at the bottom rear of the shelf.
Complete the
Step 5
Continue with the
Step 6
Stop. You have completed this procedure.
NTP-E8 Replace the Rear Cover
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Grasp the clear plastic cover on each side.
Step 1
Align the cover with the holes provided for the screws.
Step 2
Screw the retaining screws that hold the clear plastic cover in place.
Step 3
Stop. You have completed this procedure.
Cisco ONS 15600 Procedure Guide, R7.0
1-12
"NTP-E8 Replace the Rear Cover" procedure on page
"NTP-E7 Perform the Bay Installation Acceptance Test" procedure on page
This procedure replaces the rear cover.
Screwdriver
Retaining screws
As needed
Onsite
None
Chapter 1 Install the Bay and Backplane Connections
1-12.
1-13.
78-17203-01