Download Print this page

Cisco ONS 15600 Installation Instructions Manual page 11

Install the bay and backplane connections
Hide thumbs Also See for ONS 15600:

Advertisement

Chapter 1
Install the Bay and Backplane Connections
NTP-E5 Remove the Rear Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Partially unscrew the retaining screws that hold the plastic cover in place.
Step 1
Grasp the cover on each side and slide it to the left so it is free of the key holes.
Step 2
Pull the cover away from the bay.
Step 3
Continue with the
Step 4
procedure on page
Stop. You have completed this procedure.
NTP-E6 Install Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This equipment is suitable for intrabuilding wiring only.
Caution
Complete the
Step 1
are necessary to create external alarms and controls.
Complete the
Step 2
you are using a 100-ohm T1 building integrated timing supply (BITS) timing source.
Complete the
Step 3
the LAN port on the Timing and Shelf Controller [TSC] card) are necessary to create an external LAN
connection.
Step 4
Complete the
cables (or the RJ-45 port on the TSC) are required to access TL1.
78-17203-01
This procedure removes the rear cover to provide access to the customer
access panel (CAP).
None
NTP-E2 Install the Bay Assembly, page 1-5
Required
Onsite
None
"NTP-E6 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-11.
This procedure explains how to install alarm, timing, LAN, and craft wires.
Wire-wrap tool (suitable for #22 to #28 AWG alarm wires)
#22 or #24 AWG alarm wires
NTP-E4 Install the Bay Power and Ground, page 1-9
As needed
Onsite
None
"DLP-E11 Install Alarm Wires on the CAP" task on page 16-16
"DLP-E12 Install T1 (100 Ohm) Timing Connections on the CAP" task on page 16-20
"DLP-E13 Install LAN Cables on the CAP" task on page 16-21
"DLP-E14 Install the TL1 Craft Interface Cable" task on page 16-21
NTP- E5 Remove the Rear Cover
as necessary. Alarm wires
as needed. LAN cables (or
as needed. Craft
Cisco ONS 15600 Procedure Guide, R7.0
if
1-11

Advertisement

loading