Cisco ONS 15600 Installation Instructions Manual page 3

Chapter 1 Install the Bay and Backplane Connections
•
User-Supplied Materials
The following materials and tools are required but are not supplied with the ONS 15600:
•
•
•
•
•
•
•
•
•
•
•
•
Tools Needed
•
•
•
•
•
•
•
•
•
•
•
78-17203-01
Rear kick plate
–
Side kick plates (2)
–
8-32 flathead screws (18)
–
600-mm kick plate kit (53-2177-XX) (optional)
Front kick plate
–
Rear kick plate
–
8-32 flathead screws (10)
–
Power cable, rated for at least 125-A capacity
Ground cable, rated for at least 125-A capacity
Marking pen
Concrete drill
Listed pressure terminal connectors such as two-hole ring; connectors must be suitable for the
chosen cable
Two-hole power lugs, 0.625-inch hole spacing, 0.25-inch bolt holes (2 for grounding, 4 for each
shelf), for underfloor-routed power cables (Panduit LCCF2-14AZFW-E)
#22 or #24 AWG CAT-5e alarm wires
Straight-through (CAT-5) LAN cables, shielded (if using an external LAN connection)
Male 15-pin D-sub shielded cable (if using the audible [external] alarms option)
EIA/TIA-232C shielded cable (9 pin D-sub to 9 pin D-sub) (2)
75-ohm coaxial cable (BNC connectors on both ends) (optional)
Ladder (optional)
Wire-wrap tool (suitable for #22 to #28 AWG alarm wires)
Wire cutters
Wire strippers
Crimp tool
Scissors
#2 Phillips screwdriver, 6 inches long
3/4-inch socket wrench
Ratchet
6-inch (or greater) ratchet extension (optional)
3/4-inch socket
1 1/8-inch socket
Required Tools and Equipment
Cisco ONS 15600 Procedure Guide, R7.0
1-3