Keithley 7011-S Instruction Manual page 33

3.3.4 Multi-pin (mass termination) connec-
tor card
Since comections to external circuiq are made at the
96-pin male DIN bulkhead connector, there is no need
to separate the connector card from the relay card. If
the connector card is separated from the relay card,
carefully mate them together and install tlw supplied
440 mounting screw. Make sure to handle the cards by
the edges and shields to avoid contamination.
Terminal identification for the DIN connedor of the
multi-pin connector card is provided by Figure 3-8.
This connector will mate to a 96-pin female DIN con-
nector.
Keithley has a variety of cable and connector accesso-
ries available to accommodate connections from the
connector card to test instrumentation and DUT (de-
vices under test). In general, these accessories, which
are summarized in Table 3-2, utilize a round cable as-
sembly for connections.
Table 3-2
Mass termination accessories
Model
7011-m-R
7011~ME-2
Description
96pin female DIN connector and
housing for round cable.
Two-meter round cable assembly
terminated with a 96-pin female
DIN comwctor on each end.
7011~MTR
96-pin male DIN bulkhead con-
nector.
1
3-6