Keithley 7011-S Instruction Manual page 31

Card Connections & Installation
:umper installation
Referring to Figure 3-4 for jumper locations, perform
the following steps to install backplane TOW jumpers:
1. If mated together, separate the relay card from the
connector card by removing the mounting screw
and pulling the two cards away from each other.
Remember to only handle the cards by the edges
and shields to avoid contamination.
2.
Physically remove a cut jumper by unsoldering it
from the PC board.
3.
Install a new #22 AWG jumper wire o(eithley P/N
J-15) and solder it to the PC board.
4.
Remove the solder flux from the PC board The
cleaning pmcedure is explained in paragraph 5.2.
7011 Relay
Card
e
a.. . . .
::: . . .
. . .
. . .
;~
. . .
. . .
. . .
. . .
. . .
. . .
.,* . . .
. . .
0
I
Figure 34
Backplane jumpers
3.3.3 Screw terminal connector card
Figure 3-5
Mode/ 7077 screw terminal connector card
The screw terminal connector card is shown in Figure
3-5.
Connections are made directly to the screw termi-
nals of the twelve terminal blocks. Each screw terminal
will accommodate #X-22 AWG wire.
3-4