Table of Contents
Advertisement
Chapter 2 Install Cards and Fiber-Optic Cable
As needed, complete the
Step 5
page
Step 6
As needed, complete the
page
Step 7
Continue with the
Stop. You have completed this procedure.
NTP-D245 Route Fiber-Optic Cables
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
As needed, complete the
Step 1
for all STM-N cards except the STM-64, OC192SR1/STM64IO Short Reach, OC192/STM64 Any Reach
(STM64-XFP), and STM-16 AS cards.
Open the fold-down front door on the cable-management tray
Step 2
Figure 2-2
Route the fiber cable on the card faceplate through the fiber clip on the faceplate
Step 3
are factory-attached to the faceplate of the STM-N cards.
78-18118-01
"DLP-D337 Install Fiber-Optic Cables for SNCP Configurations" task on
20-32.
"DLP-D338 Install Fiber-Optic Cables for MS-SPRing Configurations" task on
20-35.
"NTP-D245 Route Fiber-Optic Cables" procedure on page
This procedure routes fiber-optic cables.
None
NTP-D19 Install Fiber-Optic Cables on Optical Cards, page 2-16
NTP-D286 Install the FC_MR-4 Cards, page 2-12
As needed
Onsite
None
"DLP-D45 Install the Fiber Boot" task on page
Fold-Down Front Door of the Cable-Management Tray
F A N
F A IL
C R
IT
M A
J
M IN
NTP- D245 Route Fiber-Optic Cables
2-19.
17-33. Fiber boots are required
(Figure
2-2).
(Figure
Cisco ONS 15454 SDH Procedure Guide, R8.5
2-3). Fiber clips
2-19
Advertisement
Table of Contents
