Cisco ONS 15454 SDH Procedure Manual page 21

Chapter 2 Install Cards and Fiber-Optic Cable
NTP-D227 Remove and Replace a Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If you are not logged into CTC and you need to remove a card, remove the card as described in
Step 1
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) using the
Cisco ONS 15454 SDH Troubleshooting Guide.
If you are logged into CTC, complete one of the following:
Step 2
•
•
Physically remove the card:
Step 3
a.
b.
Insert the new card using one of the following procedures as applicable:
Step 4
•
•
•
•
•
As needed, continue with the
Step 5
page
Stop. You have completed this procedure.
NTP-D20 Replace the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-18118-01
This procedure removes and replaces cards in the ONS 15454 SDH shelf.
None
DLP-D60 Log into CTC, page 17-44
As needed
Onsite
Provisioning or higher
Complete the "DLP-D191 Delete a Card" task on page 18-77
Complete the "DLP-D247 Change an STM-N Card" task on page 19-54
it with a different optical card while maintaining existing provisioning.
Open the card latches/ejectors.
Use the latches/ejectors to pull the card forward and away from the shelf.
NTP-D15 Install the Common Control Cards, page 2-2
NTP-D16 Install STM-N Cards and Connectors, page 2-7
NTP-D17 Install the Electrical Cards, page 2-10
NTP-D18 Install Ethernet Cards and Connectors, page 2-11
NTP-D286 Install the FC_MR-4 Cards, page 2-12
"NTP-D19 Install Fiber-Optic Cables on Optical Cards" procedure on
2-16.
This procedure replaces the front door and door ground strap after
installing cards and fiber-optic cables.
Pinned hex key
NTP-D3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
NTP- D227 Remove and Replace a Card
and continue with
to delete a card and replace
Cisco ONS 15454 SDH Procedure Guide, R8.5
Step 3.
Step 3.
2-21