luminii RSLW8 Channel Installation Instructions

RSLW8 Channel - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
1
RSLW8
profile
Refer to above dimensions when installing the RSLW8
aluminum extrusion.
3
wire leads
Line LED strip
If required to fit the new RSLW8 length, cut LineLED strip/s in
between two rows of solder pads. Always cut LineLED from
end without connector/wire leads. Ensure that LineLED strip fits
completely inside the extrusion and the solder pads do not
touch metal end caps to avoid shorting of circuit.
5
drill location
for mounting
holes
aluminum
extrusion
STEP A
mounting
surface
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
0.22"
0.89"
1.16"
countersink
ensure flathead screws are
hole for
tightened flush with or below
flathead
extrusion surface before
screws
Installing Lineled Strip/s
STEP B
Mounting for RSLW8 extrusion can
be achieved by screw fasteners or
construction adhesive. See both
mounting methods shown left and
right.
2
Always wear safety goggles when cutting.
If required for installation cut down RSLW8 aluminum extrusion
to desired length with hacksaw or miter saw that has an
appropriate blade for cutting aluminum.
4
solder
pads
Route channel into mounting material with proper
width and depth to accommodate RSLW8 aluminum
extrusion.
STEP C
OR
mounting
surface
flathead screws
aluminum
extrusion
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
Page 1 of 2
www.luminii.com
RSLW8 aluminum
extrusion
apply construction adhesive to
bottom of mounting channel
aluminum
extrusion
REV2.3