BENETEAU OCEANIS 31 Owner's Manual page 95

U
SE OF MARINE HEADS EQUIPPED WITH A WASTE HOLDING TANK
Open the water intake valve (valve handle parallel to the pipe).
In the case of a direct discharge into the sea: Open the draining valve.
In case you store the waste waters in the tank: Make sure the draining valve is closed (valve handle
perpendicular to the pipe).
To drain the bowl, set the control lever of the pump slantwise (FLUSH) then operate the pump.
To dry the bowl, set the lever vertical (DRY) then operate the pump.
In order to avoid clogging the heads:
- Only use absorbent paper inreasonable quantities.
- Schedule a regular rinsing through of the system with fresh water.
- Always retain a little water in the bottom of the bowl to avoid smells
To empty the tank:
- In an authorized area, open the draining valve.
- In a marina equipped with a system to suck the waste waters, put the sucking hose into the tank through
the deck filler. Start the pump of the sucking system. The filler caps are opened and closed with an
appropriate key. When the tank is empty, check the cap seal for condition then close the filler.
Water and sewage water
(WHT)
8
91
W
ARNING
-Ask for information about the laws in force
in your country or your marina about
discharging your waste waters into the
sea.
P
RECAUTION
-Close the valves after each use and
above all when the boat is unattended.
P
RECAUTION
-Regular check the tank level. High
pressure due to too high a level may
cause leaks or more unpleasant troubles.