Advertisement
Quick Links
Replacement Cable Kit
Kit No. 126-3925
For Serial No. 313,000,000–313,999,999
This product contains a chemical or chemicals known to the State of California to
Loose Parts
Use the chart below to verify that all parts have been shipped.
Item
Description
Part No.
1
126-1664
Cable
2
614249
Tie-Wire
3
3290-55
Rivet
© 2014—Exmark Mfg. Co., Inc.
Industrial Park Box 808
Beatrice, NE 68310
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty
1
3
2
www.Exmark.com
Form No. 4502-012 Rev A
Installation Instructions
Figure 1
Original Instructions (EN)
All Rights Reserved *4502-012* A
Printed in the USA
Advertisement
Related Manuals for Exmark 126-3925
Summary of Contents for Exmark 126-3925
- Page 1 Use the chart below to verify that all parts have been shipped. Item Description Part No. 126-1664 Cable 614249 Tie-Wire 3290-55 Rivet Figure 1 © 2014—Exmark Mfg. Co., Inc. www.Exmark.com Original Instructions (EN) All Rights Reserved *4502-012* A Industrial Park Box 808 Printed in the USA Beatrice, NE 68310...
- Page 2 Safety Alert Symbol Removing the Cable 1. Make sure all moving parts have stopped, the spark This Safety Alert Symbol (Figure 2) is used both in this plug wire has been disconnected, and the unit is cool. instruction sheet and on the machine to identify important safety messages which must be followed to avoid accidents 2.
- Page 3 7. Remove the cable anchor from the bracket on the 9. Remove and discard the self-propel drive cable. transmission case. 10. Tip the mower back onto its wheels to operating position. Installing the Cable 1. Remove and retain the serial plate from the top side of the frame.
- Page 4 13. Loosen the cable support nut. 14. Pull the cable jacket down (toward the machine) until there is no slack in the cable. Figure 8 15. Tighten the nut on the cable support. 16. Zip tie the cable to the brace to the left of the fuel tank and down the handle as shown in Figure 1.