Table of Contents
Advertisement
2–2
Installation Instructions
Publication 6151-UM001C-EN-P
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
6. Install the washers and nuts provided on the mounting studs behind
the panel.
7. Tighten the nuts evenly to 25 inch-pounds of torque.
ATTENTION: Mounting nuts must be tightened to a
torque of 25 inch-pounds to provide panel seal and avoid
potential damage to the Bulletin 6151 Industrial
Computer. Allen–Bradley assumes no responsibility for
water or chemical damage to the Bulletin 6151 Industrial
Computer or other equipment within the enclosure due to
improper installation.
Important: To assure a proper seal, be sure to install a nut and washer
on each of the mounting studs: 14 for Bulletin 6151.
8. Remove the protective adhesive sheet from the screen of the Industrial
Computer. The sheet is designed to prevent scratching of the
polycarbonate screen protector or the optional touchscreen during
shipping and installation. It should be removed before use.
Advertisement
Table of Contents
