Lutron Electronics LL-INTMOUNT Integration Manual page 5

4. LL-PIR-(L/M/H) Integration
The LL-INTMOUNT can be connected to an external Limelight by Lutron Passive Infrared sensor
(LL-PIR-[L/M/H]) through the 4-pin connector shown below.
1. Connect LL-PIR to LL-INTMOUNT with cable assembly shown below (either end can connect to either
LL-PIR or LL-INTMOUNT).
2. Recommended plastic PIR lens assembly should be tightened to 4 in-lbs (0.45 N•m) to properly engage the
internal seal.
3. Visually inspect to verify plastic PIR lens assembly is seated properly, and not tilted relative to the fixture. Tilting
could possibly imply cross-threading, which can lead to leaks and eventual failure of the product.
Consistent spacing around the perimeter
Limelight by Lutron OEM Integration Guide
Good
LL-PIR External Sensor
Connector
Uneven spacing around the perimeter
5
1.5
(38.09)
Ø1.18
(Ø29.94)
Bad
Customer Assistance: 1.844.LUTRON1
(1.844.588.7661)
1.08
(27.47)
Ø0.99
(Ø25.29)
Ø0.06
(Ø1.69)