Registration - Philips SE6554B/05 User Manual

easy access to them. Do not lose the PIN
code.
Press m in idle mode, scroll n to
Advanced Set and press o
Select.
Scroll n to Change PIN and
press o Select.
Old PIN: will be displayed. Enter
the current PIN and press o OK.
• The PIN entered will be shown
as asterisks (*) on the screen.
• If you enter an incorrect PIN
number, an error tone will sound
and "Wrong PIN!" will be
displayed. Then, you will be
prompted to enter the current
PIN again.
New PIN: will be displayed. Enter
the new PIN and press o OK.
Confirm PIN: will be displayed.
Enter the new PIN again and press
o OK to confirm PIN change.
• A validation tone is emitted,
Saved! is displayed and the
screen returns to the Advanced
Set menu.
Tip
If you forget your PIN, you will need to
reset your phone to its default settings.
For more details, see section 7.9 - "Reset
Unit."
7.6

Registration

If you wish to register an additional
handset or if you have inadvertently
unregistered your phone's handset and
want to re-register it, follow the
procedure described below. This is the
42
procedure for registering SE65 handsets.
Procedures may vary for other types of
handsets. In this case, please refer to the
manufacturer of the handset. Additional
handsets must be registered to the base
station before you can use them. Up to 5
handsets can be registered to one base
station. The PIN is required before you
can register or unregister handsets.
Note
By default, the PIN is 0000.
On the base station, press and hold
a for 3 seconds. A beep sounds to
indicate that the base is ready to
accept registration.
Note
If no action is taken on the handset
within 90 seconds, the registration
procedure will be aborted. If this
happens, repeat from Step 1.
On the handset, press m, scroll n
to Advanced Set and press o
Select.
Scroll n to Register and press o
Select.
Enter the PIN when prompted and
press o OK to confirm.
Registering... is displayed on the
screen.
• Upon successful registration, a
validation tone is emitted and the
handset number (1 to 5) will be
assigned by the base
automatically.
Advanced settings