Noise - Bosch WAX32EH0EU User Manual And Installation Instructions

en Troubleshooting
Errors
Drum jerks after the pro-
gramme starts.
Vibrations and movement of
the appliance whilst spinning.
Drum does not turn, water
does not flow in.
Heavy foam build-up
⁠ i-DOS cannot be actuated. Intelligent dosing is not inten-

Noise

Errors
Rushing, hissing noise.
Longer, whirring noise before
the start of the wash cycle or
fabric softening.
Brief whirring noise after
switching on the appliance.
Loud noises during the spin
cycle.
62
Cause
This is caused by an internal
motor test.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been re-
moved.
Load detection is active.
Detergent dosage is too high.
ded for this programme.
Programme progress does
not allow intelligent dosing.
Cause
Water is flushed under pres-
sure into the detergent
drawer.
Intelligent dosing system dis-
penses detergent or care
products.
Intelligent dosing system car-
ries out a function test.
Appliance is not correctly
aligned.
Troubleshooting
Not a fault – no action required.
▶
→ "Aligning the appliance", Page 17
▶
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 17
→ "Removing the transit bolts",
▶
Page 14
Not a fault – no action required.
▶
Note: The load detection can take up to
two minutes.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the compartment for manual dos-
ing (not for outdoor clothing,
sportswear or items stuffed with
down).
If intelligent dosing is activated, re-
▶
duce the basic dosage → Page 45.
If you dose manually, reduce the
▶
amount of detergent for the next
washing cycle with the same load.
Not a fault – no action required.
▶
No remedial action possible.
Troubleshooting
Not a fault – normal operating noise.
▶
Not a fault – normal operating noise.
▶
Not a fault – normal operating noise.
▶
→ "Aligning the appliance", Page 17
▶